SAPB1 – Configuration (Magic xpi 4.7)
When you place SAPB1 in a flow, Magic xpi automatically opens the Properties pane for the connector. You can enter the general configuration information in the Properties pane.
|
|
Before you use the SAPB1 connector, you should first define a SAPB1 resource in the Settings dialog box's Resources section. If you are going to use it as a trigger, then you also should define a SAPB1 service in the Settings dialog box's Services section.
If you are using SAPB1 as a step in a flow, you should first go to the Properties pane's Setting section and select the SAPB1 resource that you previously defined in the Settings dialog box's Resources section. If you have not yet defined an SAPB1 resource, you cannot proceed to configure the SAPB1 connector.
|
Next, you should click the Properties pane's General section, and select an interface. Then, double-click or right-click on the component and select Configuration from the context menu to open the component's Configuration dialog box. The dialog box that opens depends on which interface you selected.
SAPB1 supports the following configuration interfaces:
|
|
-
When you use a dynamic resource, at design time the connector uses the default resource to get the required schema from SAPB1.
-
Magic xpi provides configuration file flags that can be used specifically with the SAPB1 component. Click here for more information on these SAPB1-related flags.
|
